ModLight2

Description

modLight2 is our modLight module for BMW E38/E39/E53 and Range Rover L322

Instructions of use

Instructions manual: modLight2 manual
How to install modLight2 into your car?
You have to properly connect modLight2 to your car's wiring harness.
ModLight2 has 3-pin connector with BROWN, RED and YELLOW wires.
It's highly recommended to use multimeter to pre-check and confirm the power sources of your car's wire harness where you plan to connect modLight2 to.

• The BROWN wire must be connected to GND (ground) of your car's wire harness, which is usually a brown, brown-white or brown-black wire.
• The RED wire must be connected to 12V (permanent) power source from your car's wire harness, which is usually red-green, red-blue or red-white wire.
• The YELLOW wire must be connected to IBUS source (IBUS wire) from your car's wire harness, which is always a white wire with gray stripe and yellow dots.